單項選擇題You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network. It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also， if the local OSPF route goes away， the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path？（）

A.static route needs to be added
B.floating static route needs to be added
C.bgp backdoor command
D.ospf backdoor command


您可能感興趣的試卷

你可能感興趣的試題

2.單項選擇題

Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit， what could be the most likely cause of the problem？（）

A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.

4.單項選擇題

Refer to the exhibit. Routers A and B are directly connected and running EIGRP，but they are unable to form a neighbor relationship. What is the most likely cause？（）

A.The network statements are misconfigured.
B.The IP address statements are misconfigured.
C.The autonomous system is misconfigured.
D.There is a physical issue with the cable.

5.單項選擇題

Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards， the exhibit shows your configuration in a local switch1. However， EtherChannel is not coming up. Which one of these statements could be a possible reason？（）

A.EtherChannel is only available in Cisco equipment.
B.The customer side is supposed to be running PAgP， which is a Cisco standard.
C.PAgP is not an IEEE standard. VRRP should be used.
D.The configuration on switch1 needs to be modified to use LACP