91极品女神嫩模在线播放,国产精品女人高潮毛片

多項選擇題 Refer to the exhibit. As a network administrator, you have configured a dual-rate, dual-bucket policer in accordance with RFC 2698 on the serial interface of you router, connecting to your provider. The SLA with your provider states that you should only send AF31 (limited to 150 kb/s), AF32 (limited to 50 kb/s)and AF33 (best effort). Your service provider claims you are not conforming to the SLA. Which two things are wrong with this configuration?（）

A.The configuration of a service policy on half-duplex Ethernet interfaces is not supported.
B.The class class-default sub-command of the policy-map limit command should be set to the DSCP default.
C.The violate action is wrong.
D.This policer configuration is not implementing RFC 2698 dual-bucket， dual-rate.
E.The policer is configured in the wrong class.

點擊查看答案

您可能感興趣的試卷

你可能感興趣的試題

1.問答題問關(guān)于QOS的3種機(jī)制。

參考答案：1.Best-Effort Service
2.Integrated Service

點擊查看完整答案

2.多項選擇題An 802.1Q trunk is not coming up between two switches. The ports on both switches are configured as "switchport mode desirable." Assuming that there is no physical issue， choose two possible causes.（）

A.Incorrect VTP domain
B.Incorrect VTP password
C.Incorrect VTP mode
D.Incorrect VTP configuration revision

點擊查看答案

3.單項選擇題You replaced your Layer 3 switch， which is the default gateway of the end users. Many users cannot access anything now， including email， Internet， and other applications， although other users do not have any issues. All of the applications are hosted in an outsourced data center. In order to fix the problem， which one of these actions should you take？（）

A.Clear the MAC address table in the switch.
B.Clear the ARP cache in the switch.
C.Clear the ARP cache in the end devices.
D.Clear the ARP cache in the application servers.

點擊查看答案

4.問答題 在R2的show ip route ospf中，關(guān)于R1的loopback0的路由條目下一跳指向哪個路由器。

參考答案：The next hop of the route on&e...

點擊查看完整答案

5.多項選擇題The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？（）

A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q.

點擊查看答案