A.Broadcasts only use network layer addressing.
B.A broadcast frame is never forwarded by a switch.
C.A broadcast address will never be the source address of a frame.
D.Broadcast addresses use an incorrect format for the switching table.
E.Broadcast frames are never sent to switches.
您可能感興趣的試卷
你可能感興趣的試題
A.Set the SSID value in the client software to public.
B.Configure open authentication on the AP and the client.
C.Set the SSID value on the client to the SSID configured on the AP
D.Configure MAC address filtering to permit the client to connect to the AP
A.HDLC
B.Ethernet
C.Token Ring
D.PPP
E.FDDI
F.Frame Relay
A.a directly connected interface with an address of 192.168.10.254/24
B.a static route to network 192.168.10.0/24
C.a RIP update for network 192.168.10.0/24
D.an OSPF update for network 192.168.0.0/16
E.a default route with a next hop address of 192.168.10.1
F.a static route to network 192.168.10.0/24 with a local serial interface configured as the next hop
A.A CSU/DSU terminates a digital local loop.
B.A modem terminates a digital local loop.
C.A CSU/DSU terminates an analog local loop.
D.A modem terminates an analog local loop.
E.A router is commonly considered a DTE device.
F.A router is commonly considered a DCE device.
A.Switches are primarily software based while bridges are hardware based.
B.Both bridges and switches forward Layer 2 broadcasts.
C.Bridges are frequently faster than switches.
D.Switches have a higher number of ports than most bridges.
E.Bridges define broadcast domains while switches define collision domains.
F.Both bridges and switches make forwarding decisions based on Layer 2 addresses.
最新試題
Which command encrypts all plaintext passwords?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
Which IPsec security protocol should be used when confidentiality is required?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
Which statement describes the rule of split horizon?（）