單項選擇題A network administrator must configure 200 switch ports to accept traffic from only the currently attached host devices.What would be the most efficient way to configure MAC-level security on all these ports? ()

A.Visually verify the MAC addresses and then telnet to the switches to enter the switchport-port security mac-address command.
B.Have end users e-mail their MAC addresses. Telnet to the switch to enter the switchport-port security mac-address command.
C.Use the switchport port-security MAC address sticky command on all the switch ports that have end devices connected to them.
D.Use show mac-address-table to determine the addresses that are associated with each port and then enter the commands on each switch for MAC address port-security.


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which can be done to secure the virtual terminal interfaces on a router?()

A.Administratively shut down the interfaces.
B.Physically secure the interfaces.
C.Configure a virtual terminal password and login process.
D.Enter an access list and applyit to the terminal interfaces using theaccess-class command.
E.Create an access list and applyit to the terminal interfaces using theaccess-group command.

2.單項選擇題Assuming the default switch configuration,which approach should you use to configure the extended vlanrange(1006 through 4094) on a cisco catalyst 3750 series switch?()

A.Configure the switch to be in VTP client mode.
B.Configure the switch to be in VTP domaint mode.
C.Configure the switch to be in VTP transparent mode.
D.Configure the switch to be in VTPv2

3.多項選擇題Which two commands can be used to verify a trunk link configurationt status on a given cisco switch?()

A.show interfaces interface
B.show interfaces interface trunk
C.show interfaces interface switchport
D.show ip interface brief
E.show interfaces vlan

4.單項選擇題The network administrator is in a campus building distant from Building B. WANRouter is hosting a newly installed WAN link on interface S0/0. The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface. How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner()。

A.Telnet to WANRouter and execute the command show interfaces S0/0
B.Telnet to WANRouter and execute the command show processes S0/0
C.Telnet to WANRouter and execute the command show running-configuration
D.Telnet to WANRouter and execute the command show controller S0/0
E.Physically examine the cable between WANRouter S0/0 and the DCE
F.Establish a console session on WANRouter and execute the command show interfaces S0/0

5.多項選擇題

Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? ()

A.Switch A - Fa0/0
B.Switch A - Fa0/1
C.Switch B - Fa0/0
D.Switch B - Fa0/1
E.Switch C - Fa0/0
F.Switch C - Fa0/1

最新試題

請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()

題型:多項選擇題

請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet。可以為路由器接口S0/0/0分配下列哪一個IP 地址?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()

題型:?jiǎn)雾?xiàng)選擇題

在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()

題型:?jiǎn)雾?xiàng)選擇題

要將數據包發送到遠程網絡,應使用哪種設備?()

題型:?jiǎn)雾?xiàng)選擇題

在路由器上使用Router#copy running-config startup-config 命令會產生什么效果?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()

題型:多項選擇題

請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()

題型:?jiǎn)雾?xiàng)選擇題