A.The Gallant router has the wrong LM Itype configured
B.Inverse ARP is providing the wrong PVC information to the Gallant router
C.The S3 interface ofthe Steele router has been configured with the frame-relay encapsulation ietf command
D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct
E.The IP address on the serial interface of the Attalla router is configured incorrectly

A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding

A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.

A.172.25.78.243
B.172.25.98.16
C.172.25.72.0
D.172.25.94.255
E.172.25.96.17
F.172.25.100.16

A.A variance was configured for EIGRP autonomous system 109.
B.The EIGRP topology table displays all routes to a destination.
C.The EIGRP topology table shows only backup routes to a destination.
D.Multiple floating static routes were configured to network 192.168.81.0 via interface Serial0.