A.It designates VLAN 999 for untagged traffic.
B.It blocks VLAN 999 traffic from passing on the trunk.
C.It creates a VLAN 999 interface.
D.It designates VLAN 999 as the default for all unkown tagged traffic.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. What can be determined about the router from the console output?（）
A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.
A.172.1.0.0/22
B.172.1.0.0/21
C.172.1.4.0/22
D.172.1.4.0/24 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
E.172.1.4.0/25 172.1.4.128/25 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
A.VLAN 1 is the default Ethernet VLAN.
B.CDP advertisements are only sent on VLAN 1002.
C.By default, the management VLAN is VLAN 1005.
D.By default, the switch IP address is in VLAN 1005.
E.VLAN 1002 through 1005 are automatically created and cannot be deleted.
The user of Host1 wants to ping the DSL modem/router at 192.168.1.254. Based on the Host1 ARP table that is shown in the exhibit, what will Host1 do（）。
A.send a unicast ARP packet to the DSL modem/router
B.send unicast ICMP packets to the DSL modem/router
C.send Layer 3 broadcast packets to which the DSL modem/router responds
D.send a Layer 2 broadcast that is received by Host2, the switch, and the DSL modem/router
A.It converges quickly.
B.OSPF is a classful routing protocol.
C.It uses cost to determine the best route.
D.It uses the DUAL algorithm to determine the best route.
E.OSPF routers send the complete routing table to all directly attached routers.
F.OSPF routers discover neighbors before exchanging routing information.
最新試題
請參見圖示。當計算機A 向計算機D 發送幀時，哪些計算機會接收該幀？（）
請參見圖示。下列哪組設備僅包含中間設備？（）
請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是，從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題？（）
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2？（）
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口？（）
請參見圖示。哪種邏輯拓?fù)涫菍?duì)圖示網絡的準確描述？（）
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么？（）
PC 無法連接到任何遠程網站，無法ping 通其默認網關，也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常？（）
何時必須使用clock rate 命令配置路由器串行接口？（）
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序？（）